Need to change the battery on your Guardian Simon Xti Security Panel? First, make sure your system is disarmed, and then place your system on test mode. Watch the video below for a few additional steps and then you’re all set!
To replace your panel’s battery, please follow these steps:
- Log in to your Guardian Protection account.
- Select System Info and then select Test My System.
- Disarm your system.
- Remove the AC Adaptor from the outlet.
- Remove the trim ring from the face of the panel by lifting up the bottom right corner with your finger.
- Release the panel from the mounting plate by lifting up the two tabs at the top right and left of the panel.
- Follow the wires from the battery pack to the black connector and unplug it from the panel.
- Remove the battery pack by placing one finger under the end of the battery and pulling away from the retaining clip.
- Replace the batteries.
- Replace the battery pack in your panel and reattach the black connector.
- Swing the panel back up and lock it into place.
- Replace the trim ring.
- Plug the AC Adaptor back into the lower plug outlet, screwing the screw back in.
- The low battery notification on your panel should be gone automatically.
- Test your system to make sure it is working correctly.
- Take your system out of test mode.